94. Crankshaft Balancer Installation

Crankshaft Balancer Installation

- Tools Required
- J 29113 Crankshaft Balancer Installer
- J 36660-A Torque Angle Meter





1. Apply sealer GM P/N 12345739 or the equivalent to the keyway of the crankshaft balancer.
2. Place the crankshaft balancer into position over the key in the crankshaft.
3. Install the J 29113 onto the crankshaft.
4. Pull the crankshaft balancer into position.
5. Remove the J 29113 from the crankshaft balancer.

Notice: Refer to Fastener Notice in Service Precautions.





6. Install the crankshaft balancer washer and bolt.
- Tighten the crankshaft balancer bolt a first pass to 70 Nm (52 ft. lbs.).
- Tighten the crankshaft balancer bolt a final pass to 85 degrees using the J 36660-A.