Electronic Column Lock Module - Disassemble

Disassembly Procedure
1. Remove the upper tilt head components. Refer to Steering Column Tilt Head Housing - Disassemble - Off Vehicle.





2. Disconnect the park lock cable assembly (1).
The lock cylinder should be in the off-lock position.
3. Insert a small screwdriver into the slot on the lock module assembly and push against the locking tab to remove.





4. Disconnect the connectors (1) and (2) of the ignition and key alarm switch assembly.





5. Remove the control coded key (2) from the lock module assembly (1).





6. Remove the key alarm connector (1 ) from the lock module assembly (2).
7. Remove two tapping screws from the ignition and key alarm switch assembly (3).
8. Remove the ignition and key alarm switch assembly (3) from the lock module assembly (2).





9. Remove three pan head tapping screws (2) from the lock module assembly (1).
10. Remove the lock module assembly (1).