Control Assembly Replacement

REMOVAL PROCEDURE




1. Remove the right IP cluster trim plate.
2. Remove the fasteners (2) that secure the heater and A/C control.
3. Pull the heater and A/C control (1) rearward.
4. Disconnect the heater and A/C control electrical connectors.

INSTALLATION PROCEDURE




1. Connect the heater and A/C control electrical connectors.
2. Install the heater and A/C control (1).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the heater and A/C control fasteners (2).

Tighten
Tighten the fasteners to 1.8 N.m (16 lb in).

4. Install the right IP cluster trim plate.