Throttle Body Air Inlet Screen Replacement

REMOVAL PROCEDURE




1. Remove the IAT (Intake Air Temperature) sensor electrical connector (1) from the IAT sensor (2).




2. Remove the air intake duct.




3. Remove the snap ring (3) from the throttle body (1).
4. Remove the throttle body air inlet screen (2) from the throttle body.

INSTALLATION PROCEDURE




1. Install the throttle body air inlet screen (2) into the throttle body (1).
2. Install the snap ring on to the throttle body.





NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the air intake tube.

Tighten
Tighten the air intake tube clamp to 2 N.m (18 lb in).




4. Connect the IAT sensor electrical connector (1) to the IAT sensor (2).