Garnish Molding Replacement - Rear Door Frame

REMOVAL PROCEDURE




1. Remove the trim panel.
2. Remove the fastener at the rear edge of the door molding.
3. Use the J 38778 in order to remove the push pin (2) at the front lower corner.
4. Pull straight down on the molding (1) in order to release the clips.

INSTALLATION PROCEDURE




1. Position the garnish molding (1) on the door frame.
2. Install the push pin (2) to locate the molding.
3. Press the molding (1) into place.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the fastener at the rear edge of the door molding.

Tighten
Tighten the fastener to 2 N.m (18 lb in).

5. Install the trim panel.