Shift Control Replacement

Removal Procedure





1. Remove the Console Trim Plate. Refer to Trim Plate Replacement - Console Front in Instrument Panel, Gauges and Warning Indicators.
2. Remove the console wiring harness.





3. Remove the console shift control wiring harness, right side.





4. Remove the console shift control wiring harness, left side.
5. Remove the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement (New Cable Installation Only).





6. Remove the console shift control nuts.
7. Remove the console shift control.

Installation Procedure





1. Install the console shift control.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the console shift control nuts.
^ Tighten the console shift control nuts to 24 Nm (18 ft. lbs.).





Important: Install the shift control in the NEUTRAL position. Use the lever on the passenger side of the shifter to depress and move out of the PARK position if the console shift control is inadvertently moved to the PARK position. Remove the shift lever release cover (1) to access the lever if the console is installed and the console shift control is inadvertently moved to the PARK position.

3. Place the shift control lever in NEUTRAL.
4. Install the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement (New Cable Installation Only).





5. Install the console shift control wiring harness, right side.





6. Install the console shift control wiring harness, left side.





7. Install the console wiring harness.
8. Install the Console Trim plate. Refer to Trim Plate Replacement - Console Front in Instrument Panel, Gauges and Warning Indicators.
9. Adjust the transaxle side automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement (New Cable Installation Only).