Exhaust Muffler Hangers Replacement (Pipe Rear Bracket)

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.

Notice: To prevent internal damage to the flexible coupling of the catalytic converter assembly, the converter must be supported. The vertical movement at the rear of the catalytic converter assembly must not exceed 6 degrees up or down.

2. Suitably support the exhaust system.
3. Remove the exhaust pipe rear hanger insulator from the exhaust pipe rear hanger bracket.
4. Remove the exhaust pipe rear hanger bolt.
5. Remove the exhaust pipe rear hanger bracket.

Installation Procedure





1. Install the exhaust pipe rear hanger bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the exhaust pipe rear hanger bolt.
Tighten the exhaust pipe rear hanger bolt to 25 Nm (18.4 ft. lbs.).
3. Install the exhaust pipe rear hanger insulator to the exhaust pipe rear hanger bracket.
4. Remove the support from the exhaust system.
5. Lower the vehicle.
6. Inspect the exhaust system for leaks and underbody contact.