Installation Procedure

Description:

1. Install the belt retractor into the T-slot in the center pillar.

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Install the retractor side belt bolt.
Tighten
Tighten the retractor side belt bolt to 42 N.m (31 lb. ft).
3. Install the intermediate guide bolts.
Tighten
Tighten the intermediate guide bolts to 10 N.m (89 lb. in).
4. Position the anchor plate to the seat stud.
5. Install the anchor plate nut to the seat stud.
Tighten
Tighten the anchor plate nut to 42 N.m (31 lb. ft).
6. Install the center pillar lower trim. Refer to Center Pillar Lower Trim Panel in Doors.
7. Position the guide loop to the guide adjuster bracket.
8. Install the guide loop nut.
Tighten
Tighten the guide loop nut to 42 N.m (31 lb. ft).
9. Close the guide loop cover.