Accelerator Pedal: Service and Repair

Removal Procedure
1. Remove the left instrument panel sound insulator. Refer to Instrument Panel, Gages and Console.
2. Remove the accelerator cable (5) from accelerator pedal (1).
3. Remove the bolts (2) and studs (3) holding the accelerator pedal to the bulk head (4).
4. Remove the accelerator pedal.

Installation Procedure
1. The accelerator pedal (1) to bulkhead (4).
2. The accelerator pedal bolt (3) and stud (2).
Tighten
The accelerator pedal assembly bolts and studs to 3.0 Nm (27 lb. in.).

Notice: Refer to Fastener Notice in Precautions.

3. The accelerator cable (5) to accelerator pedal (1).
4. The left instrument panel sound insulator. Refer to Instrument Panel, Gages and Console.
5. Inspect the accelerator pedal.
^ Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.
^ The throttle should operate freely without binding between full closed and wide open throttle.