Shift Modulator: Service and Repair

REMOVE OR DISCONNECT
1. Vacuum line at modulator.
2. Bolt and retainer
3. Modulator and O-ring.
^ Use care to avoid losing modulator valve from transaxle case.

INSTALL OR CONNECT
1. Modulator and new O-ring.
2. Retainer and bolt.

Tighten
^ Bolt to 20 to 27 Nm (15 to 20 ft. lbs.).

NOTICE: Insure the correct vacuum line is connected to the vacuum modulator on the 2.4L. The correct vacuum line is a short hose from the main harness to the modulator. It DOES NOT have a black and white vacuum check valve in-line with it. Transaxle damage may occur if the incorrect vacuum line is connected.





NOTICE: Modulator vacuum orifice must be installed in the correct position. Transaxle damage may occur if the orifice is installed backwards.

3. Vacuum line at modulator.