Ignition Lock Actuator & Lock Bolt Assemblies

STEERING COLUMN LOCK CYLINDER SET
IGNITION LOCK ACTUATOR ASSEMBLY
LOCK BOLT ASSEMBLY

Removing Lock Cylinder & Lock Bolt:

Standard Steering Column (1 Of 2):

Standard Steering Column - Legend (2 Of 2):

REMOVE OR DISCONNECT
1. Steering column lock cylinder set (13).
A. Turn lock cylinder (13) to "RUN" position.
B. Push against locking button on back side of steering column housing assembly (11) and remove lock cylinder (13).
C. Ground strap (15) from lock pre-loadspring (14).
D. Lock pre-load spring (14).

2. Ignition lock actuator assembly (12) from steering column housing assembly (11) with needle nose pliers.
3. Lock bolt assembly (21).
4. Negative (-) battery cable.
5. Disable the SIR system.
6. Air bag module and steering wheel.

NOTICE: SIR coil assembly (3) will become uncentered if:
1) Steering column is separated from steering gear and allowed to rotate.
2) Centering spring is pushed down, letting hub rotate while coil (3) is removed from steering column. If this occurs refer to "Centering SIR Coil Assembly" (4) to center coil (3).

7. Retaining ring (2).
8. SIR coil assembly (3).
^ Let sir coil assembly (3) hang freely.

9. Shaft lock retaining ring (5) using J 23653-SIR to push down shaft lock (6).
^ Dispose of ring (5).
^ Shaft lock (6).
B. Two tapping screws (23).
C. Lock bolt support bracket (22).
D. Lock bolt asm (21) and lock bolt spring (16) from housing assembly(11).

INSTALL OR CONNECT
1. Lock bolt assembly (21) and upper steering column housing components to steering column housing assembly (11).
A. Lock bolt spring (16).
B. Lock bolt assembly (21).
C. Lock bolt support bracket (22).
D. Two tapping screws (23).
^ Seat upper tapping screw (23) first and lower screw (23) second.

Tighten
^ Tighten two screws (23) to 3.4 Nm (30 lb.in.).

2. Shaft lock (6).
^ Align inner block tooth of lock plate to block tooth of steering shaft assembly (26).
^ Lubricate with grease, synthetic (service kit).

3. New shaft lock retaining ring (5) using J 23653-SIR to push down shaft lock (6).
^ Ring (5) must be firmly seated in groove on shaft.

4. Center steering shaft assembly (26) and SIR coil assembly (3).
A. Wheels straight ahead.
^ Block tooth and centering mark on shaft assembly (26) at 12 o'clock position.
B. Ignition switch to "LOCK" position.
C. Ensure coil (3) is centered.

5. Ignition lock actuator assembly (12) to housing assembly (11).
A End of lock bolt asm (21) flush with support bracket (22).
B. Ignition lock actuator assembly (12) to housing assembly (11).
C. Rotate actuator (12) counterclockwise until it pushes out lock bolt asm (21) and actuator (12) seats into housing assembly (11).
D. Rotate actuator (12) clockwise to "RUN" position.

6. Lock pre-load spring (14) to housing assembly (11).
7. Ground strap (15) to preload spring.

8. Steering column lock cylinder set (13).
^ Key installed in lock cylinder (13).
^ Ensure sector is in "RUN" position.
^ Line up locking tab with slot in housing assembly (11) and push into position.