Wiper Blade Assembly Replacement

Description:

Remove or Disconnect
1. Turn ignition switch to "ACCY" position.
2. Set wiper switch to "PULSE" position.
3. Turn ignition switch off when wipers are at bottom of innerwipe and not moving.
4. Wiper blade assembly (15) from wiper arm assembly (14).
^ Push down on latch (F) and pull wiper blade assembly (15) from wiper arm assembly (14).

Install or Connect

IMPORTANT
^ Use only 22-inch beam type blade assemblies. At innerwipe, blade assemblies must be installed with wiper blade insert notches (H) pointed toward passenger side of vehicle as shown in image.
1. Wiper blade assembly (15) on wiperarm assembly (14).
2. Operate wipers and check operation.