Install or Connect

^ Tools Required:
- J 28467-A Engine Support Fixture.
- J 28467-94 Engine Support Fixture Adapter.
- J 28467-330 Engine Support Fixture Adapter.
- J 28467-350 Engine Support Fixture Adapter.
- J 37292-B Axle Seal Protector.

To complete installation, observe the following assembly tips and reverse the removal procedures.

Assembly Tips
- Use care when installing right side drive axle into the transaxle case. The splined shaft can easily damage the seal.

Important
- Before installing right side drive axle, be sure to install tool J 37292-B axle seal protector.
- Line up the flywheel to torque converter marks made at disassembly.
- Torque converter to flywheel bolts should always be tightened twice. The final torque should be 62 N.m (46 lb. ft.).
- Check adjustment of the shift cables. Re-adjust as needed.
- After installing front wheel and tire assemblies, torque wheel nuts to specifications.
- Check and adjust the fluid level as needed.
- Road test and check for leaks.
- When installing transaxle to engine block brace, tighten brace to engine bolts first and brace to transaxle case last to avoid pulling transaxle case out of line.