Supercharger Installation

1. Install the supercharger gasket.
2. Install the supercharger.
3. Install the spacers, bolts, and stud to the supercharger in the proper locations.
^ Tighten the stud/bolts to 23 Nm (17 ft. lbs.).
4. Install the Throttle Body Injection (TBI) nuts.
^ Tighten the TBI nuts to 10 Nm (89 inch lbs.).
5. Install the Manifold Absolute Pressure (MAP) sensor bracket bolts.
^ Tighten the MAP sensor bracket bolts to 30 Nm (22 ft. lbs.).
6. Install the bolts to the vacuum block.
7. Install the boost solenoid bolts.
^ Tighten the bolts to 26 Nm (19 ft. lbs.).
8. Install the regulator valve and harness bolt.
9. Install the booster bypass nut.
10. Install the fuel rail.
11. Install the fuel rail nuts.
^ Tighten the nuts to 10 Nm (89 inch lbs.).
12. Install the vacuum line from the fuel rail.
13. Install the spark plug wire clips to the supercharger.
14. Install the Ignition Control Module (ICM) harness to the fuel rail.