Engine Installation

1. Lower the engine.
2. Install the engine to transmission bolts.
3. Install the torque axis engine mount.
4. Raise the vehicle. Suitably support the vehicle.
5. Install the torque converter to flywheel bolts. Ensure that the relationship between the converter and the flywheel is the same as it was prior to assembly. Refer to Transmission and Drivetrain.
6. Install the starter motor. Refer to Starting and Charging.
7. Install the flywheel cover. Refer to Transmission and Drivetrain.
8. Install the engine to the transmission bracket.
9. Install the A/C compressor.
10. Install the exhaust pipe to the right manifold.
11. Lower the vehicle.
12. Install the brake booster hose to the engine vacuum connections.
13. Install the heater control hoses to the engine vacuum connections.
14. Install the emission control canister hoses to the throttle body connections.
15. Connect the fuel feed and return lines to the fuel rail. Connect the fuel lines to the fuel pressure regulator.
16. Install the ignition coil ground strap to the fender inner panel.
17. Connect the wiring harness connectors to the following locations:
^ The MAT sensor
^ The throttle position sensor
^ The idle air control valve
^ The oxygen sensor
^ The A/C compressor
^ The oil pressure switch
^ The power steering cutout switch
^ The Vehicle Speed Sensor (VSS)
^ The low oil level sensor
18. Install the throttle cable to the throttle linkage.
19. Install the engine mounting bracket.
20. Install the other applicable cables.
21. Install the air flow duct.
22. Install the power steering pump to the engine. Refer to Steering and Suspension.
23. Install the drive belt.
24. Connect the engine harness connector to the bulkhead.
25. Connect the negative battery cable to the engine block.
26. Install the radiator supply hoses. Refer to Cooling System.
27. Install the heater supply hoses.
28. Refill the coolant. Refer to Cooling System.
29. Refill the engine oil.
30. Connect the negative battery cable.
31. Check for the proper ok level.
32. Check the fluid levels.
33. Inspect for fluid leaks.
34. Inspect for the proper completion of repairs.
35. Install the hood.