Rocker Arm Assembly: Service and Repair

REMOVAL
1. Remove the rocker arm cover/ valve cover.
2. Remove the rocker arm pedestal retaining bolts.
3. Remove the pedestal.

NOTE:
^ Place the assemblies on a clean surface.
^ Store the components in order. Reassemble the components in the same location and with the same mating surfaces as when removed.

4. Remove the rocker arm assembly.
5. Clean the rocker arms and pedestal bolts in a suitable solution.
6. Inspect the rocker arms and pedestal bolts for wear.
7. Clean the bolts of all thread adhesive.

TOOLS REQUIRED
J 36660 Torque Angle Meter or equivalent.

INSTALLATION
1. Install the rocker arm assembly.
2. Install the pedestal.

CAUTION: This bolt is designed to permanently stretch when tightened. The correct part number fastener must be used to replace this type of fastener. Do not use a bolt that is stronger in this application. if the correct bolt is not used, the parts will not be tightened correctly. The system or the components may be damaged.

3. Apply thread lock compound or the equivalent to the rocker arm bolt threads.
4. Install the rocker arm pedestal retaining bolts.
^ Tighten the bolts to 15 Nm (11 ft. lbs.) plus 90° using the J 36660.
5. Install the rocker arm cover/ valve cover.
6. Inspect for proper completion of repairs.
7. Listen for valve train noise.