Installation Procedure

1. Install the oil pump pipe and screen with a new gasket.
2. Install the oil pump pipe and crnen attaching bolts. Tighten the bolts to 15 Nm (11 lb. ft.). Refer to Fastener Notice in General Information
3. Install the oil pan. Refer to 011 Pan Replacement.

Notice: Do not run the engine until the oil pressure is tested. Running the engine without measurable oil pressure will cause extensive damage.

Notice: Stop the engine and remove the oil pan if the oil pressure does not build up immediately. Check the oil pump pipe and the screen for a clogged screen, damaged pipe, or a damaged gasket. Running the engine without measurable oil pressure will cause extensive damage.

4. Inspect the oil pressure.