Door Lock Cylinder

Installing Door Lock Cylinder:

Installing Door Lock Cylinder:

Remove or Disconnect

Important
^ Window must be in the full-up position.

1. Negative battery cable.
2. Trim panel.
3. Water deflector.
4. Outside handle assembly.
5. Any wire harness, if present.
6. Nut and retainer.
7. Cylinder.

Install or Connect

1. Gasket over cylinder.
2. Cylinder (including any wire harnesses that may be attached).
3. Retainer and nut.
4. Outside handle assembly.
5. Any wire harness, if present.
6. Rods.
7. Water deflector.
8. Trim panel.
9. Negative battery cable.