Actuator - Power Window

Front and Rear

Installing Actuator:

Remove or Disconnect

1. Ensure window is 1 inch below full up position.

CAUTION: If door module assembly is removed from vehicle, relieve tension on actuator spring using tool J 38864 or equivalent. Failure to relieve tension on actuator spring could cause the cross arm assembly to suddenly spring closed when removing power window actuator, resulting in personal injury.

2. Negative battery cable.
3. Trim panel and water deflector.
4. Nuts.
5. Actuator.

Install or Connect

1. Actuator.
2. Nuts.
3. Water deflector and trim panel.
4. Negative battery cable.