Troubleshooting Hints - Indicator Cluster

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. Check Fuse 8 in I/P Fuse Block and Fuse 9C in RH I/P Power Distribution Center by visual inspection.
2. check indicator bulbs.
3. If more than one indicator or gauge is out, check common power and ground inputs.
4. Before component replacement, check for poor terminal contact at component connectors and in-line harness connectors; refer to Troubleshooting Procedures.
5. Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove good in a continuity/voltage check. (Refer to Troubleshooting Procedures.)
6. Check for proper installation of aftermarket electronic equipment which may effect the integrity of other systems. (Refer to Troubleshooting Procedures.) Diagnostic Aids