Clearing Diagnostic Trouble Codes (DTC)

TWO METHODS
The DTCs in the Electronic Brake/Traction Control Module (EBCM/EBTCM) memory are erased in one of two ways:
1. Scan Tool method.
2. Ignition cycle default.

NOTE: Whichever method is used, be sure to verify proper system operation and absence of DTCs when the clearing procedure is completed. DTCs cannot be cleared by unplugging the EBCM/EBTCM, disconnecting the battery cables, or by turning the ignition "OFF" (except on the 50th cycle of ignition cycle default).

SCAN TOOL METHOD
Refer to the Scan Tool Operators Manual.

IGNITION CYCLE DEFAULT
If the ignition is cycled 100 times (50 engine START cycles), without a particular malfunction reappearing, that DTC will be erased from EBCM/EBTCM memory and the ignition cycle counter in the EBCM/EBTCM will be reset to zero.