Rear Door

REAR DOOR ACTUATOR - POWER WINDOW (MOTOR)






1. Ensure window is 1 inch below full up position, then remove trim panel and water deflector.

CAUTION: If door module assembly is removed from vehicle, relieve tension on actuator spring using tool J 38864 or equivalent. Failure to relieve tension on actuator spring could cause the cross arm assembly to suddenly spring closed when removing power window actuator, resulting in personal injury.

2. Remove three retaining nuts.
3. Disconnect electrical connector.
4. Remove power window actuator.
5. Reverse steps for installation.

IMPORTANT: When installing actuator, ensure teeth on actuator pinion align with teeth on crossarm assembly.