Front Door

FRONT DOOR WINDOW ADJUSTMENT






1. Remove trim panel, trim brackets and upper half of water deflector.
2. Loosen front run channel bolts.
3. Loosen window-to-module sash nuts.
4. Move glass studs rearward in module sash.
5. Tighten front run channel upper bolt in middle of slot. Tighten lower bolt.
6. Raise window to full up position.
7. Pry up on window sash using front driver access hole.
8. Tighten rear window to module sash nut then tighten front window to sash nut.
9. Cycle window up and down to check operation.
10. Install water deflector, trim brackets and trim panel Water deflector must adhere well with no wrinkles at bottom.