Rocker Arm Studs Replace

Fig. 8 Removing Rocker Arm Stud:

Fig. 9 Installing Rocker Arm Stud:

If studs are loose in cylinder head, .003 inch or .013 inch oversize studs may be installed after reaming holes with a proper size reamer.
1. Remove the old stud by placing a suitable spacer, Fig. 8, over stud. Install nut and flat washer and remove stud by turning nut.
2. Ream hole for oversize stud.
3. Coat press-fit area of stud with rear axle lube. Then install new stud, Fig. 9. If tool shown is used, it should bottom on the head.