Forward Clutch Shaft Endplay Check

Forward clutch shaft endplay should be checked prior to removal. If endplay is not within specifications, check for damaged or improperly assembled parts. Check endplay as follows:

a. Push forward clutch shaft down, then install output shaft and rear unit support fixture J-25013 and output shaft support fixture J-29332 or their equivalents.






b. Install forward and direct endplay checking device J-29337, post tool J-25025-7A and dial indicator J-8001 or their equivalents.

c. Turn adjusting screw on J-29332 until white/scribe line on J-25013-1 begins to disappear.






d. Zero dial indicator, then lift on J-29337. Endplay should be 0.022 - 0.051 inch. Refer to chart for proper washer thickness. Do not remove output shaft and rear unit support fixture J-25013 or output shaft support fixture J-29332.