Headlamp Switch: Service and Repair

Fig. 6 Switch Replace:

1. On models equipped with airbags, disable airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. On all models, disconnect battery ground cable, then remove left lower instrument panel trim, then A/C ducts as required.
3. Pull headlamp switch to full on position, then depress retainer through slot in rear of knob and pull knob from stem, as applicable, Fig. 6.
4. Remove switch stem escutcheon and instrument cluster bezel.
5. Remove nut securing switch, lower switch from rear of instrument panel, then disconnect electrical connector from switch.
6. Reverse procedure to install.
7. Rearm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.