Instrument Cluster Replacement

Fig. 19 Speedometer & Fuel Gauge Replace:

On these models, the speedometer and fuel gauge are removed from the instrument panel carrier as separate assemblies.
1. On models equipped with airbags, disable airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. On all models, disconnect battery ground cable.
3. If speedometer is to be removed, disconnect speedometer cable from transmission, cruise control transducer or union in engine compartment.
4. Pull steering column filler forward, then remove headlamp switch knob as outlined previously.
5. Remove left (cluster) trim bezel, grasping bezel on both sides and pulling straight away from instrument panel.
6. Remove fuel gauge, Fig. 19, as follows:
a. Remove 4 screws securing gauge.
b. Withdraw gauge assembly from carrier, remove bulb sockets, then disconnect electrical connector from gauge.
7. Remove speedometer, Fig. 19, as follows:
a. Remove 4 screws securing speedometer.
b. Withdraw speedometer just far enough to gain access to cable and electrical connections.
c. Remove bulb sockets, then disconnect cable from speedometer.
d. Remove screws securing speed sensor optic head, then disconnect sensor from speedometer.
e. Remove speedometer.
8. Reverse procedure to install.
9. Rearm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.