E: Fuel Gage Accuracy Test

(J33431 Tester Available)

Disconnect connector C305 and connect one red lead of tester J33431 to terminal B PPL and the other to terminal E (BLK/WHT) of the harness half of connector C305. Turn the Ignition Switch to RUN. Set the resistance dials of the tester to 0 ohms and then to 90 ohms. The Fuel Gage should read E and then F. Turn the Ignition switch back to OFF then to RUN before setting the tester to 90 ohms.

^ If the gage responds correctly, replace the Fuel Gage Sender and its wires.

^ If the gage does not respond correctly, replace the Instrument cluster (see Service and Repair).