DTC 24

Chart - Code 24 Vehicle Speed Sensor:

Wiring Diagram for Vehicle Speed Sensor.:

CIRCUIT DESCRIPTION
Vehicle speed information is provided to the Electronic Control Module (ECM) by the vehicle speed sensor which uses a Permanent Magnet (PM) generator and it is mounted in the transaxle. The PM generator produces a pulsing voltage whenever vehicle speed is over about 3 MPH. The AC voltage level and the number of pulses increases with vehicle speed. The ECM then converts the pulsing voltage to MPH which is used for calculations, and the MPH can be displayed with a "SCAN" tool. Output of the generator can also be seen by using a digital voltmeter on the AC scale while rotating the generator.
The function of Vehicle speed Sensor (VSS) buffer used in past model years has been incorporated into the ECM. The ECM then supplies the necessary signal for the instrument panel (4000 pulses per mile) for operating the speedometer and the odometer. If the vehicle is equipped with cruise control the ECM also provides a signal (2000 pulses per mile) to the cruise control module.

NOTE: Disregard a Code 24 set when drive wheels are not turning.

TEST DESCRIPTION
Numbers below refer to circled numbers on the diagnostic chart.

1. Code 24 will set if vehicle speed equals 0 MPH when:
^ Engine speed is between 2200 and 4400 RPM.
^ Throttle is closed.
^ Low load condition (low air flow).
^ Not in park or neutral.
^ No Code 21, 22, 33 or 34.
^ All conditions met for 3 seconds.

NOTES:
^ These conditions are met during a road load deceleration. Disregard Code 24 that sets when drive wheels are not turning.
^ The PM generator only produces a signal if drive wheels are turning greater than 3 MPH.

DIAGNOSTIC AIDS:
"SCAN" should indicate a vehicle speed whenever the drive wheels are turning greater than 3 MPH. A problem in circuit 389 will not affect the VSS input or the readings on a "SCAN". Check circuit 400 and 401 for proper connections to be sure there clean and tight and the harness is routed correctly.

Refer to Diagnosis by Symptom / Intermittents. - Intermittent Malfunctions

NOTE: (A/T) A faulty or misadjusted park/neutral switch can result in a false Code 24. Use a "SCAN" and check for proper signal while in overdrive (440-T4). For P/N switch diagnosis refer to Computers and Controls / System Diagnosis / Diagnostic Charts / Chart C-1A. Chart C-1A Park/Neutral Switch Diagnosis