Owner Notification, Change of Owner, Technical Procedure & Warranty Information
OWNER NOTIFICATIONOwners of vehicles involved in this campaign will be notified by Buick Motor Division (see copy of Owner Letter included with this bulletin).
CHANGE OF OWNER INFORMATION
Dealers are to use the Dealer Communication System (D.C.S.) to provide Buick Motor Division with subsequent Buick owner information. By reporting a change of owner name or address of a vehicle in campaign status over the D.C.S., the need to send in a C.V.A.R. form for that vehicle is eliminated. Terminal input instructions are covered in the D.C.S.. Manual Section 9, page 9-JO1A and B.
TECHNICAL PROCEDURE
1. Disconnect negative battery cable at the battery.
2. Remove generator from the vehicle using established Service Manual
3. Make scribe marks on both end frames of generator to facilitate reassembly.
4. Remove four thru-bolts. and separate drive end frame assembly from rectifier end frame assembly.
5. Clean brushes with soft, dry cloth (if necessary) and reassemble brushes into the brush holder using brush retainer wire through end frame and brush holder.
6. Reassemble the two end frames with the rectifier end frame rotated 90~ clockwise from original position. The scribe marks (step No. 3) should now be 90~ apart.
7. Install generator on the vehicle using Remove Procedures in reverse.
8. Connect negative battery cable.
When installed on the engine, the "Bat" terminal should be in the 9 o'clock position when viewed from the rectifier end frame or inboard side of generator.
Campaign Identification Label:
9. Install a Campaign Identification Label.
Each vehicle modified in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label." Each label provides a space to include the five-digit dealer code of the dealer performing the campaign service. This information may be inserted with a typewriter or ballpoint pen.
Each "Campaign Identification Label" is to be located near the Emission (tune-up) label in an area which will be visible when the vehicle is brought in for periodic servicing by the owner.
Apply "Campaign Identification Label" only on a clean, dry surface.
WARRANTY INFORMATION
Dealers are to submit each campaigned vehicle as a separate case on the one-line warranty document form S-764. Dealers submitting warranty claims by teletype terminal are to transmit campaign completions as a separate case only.
FAILURE OPER. LABOR OTHER SUBLET
OPERATION COUNT PART NO. ALLOW. CODE NO. HOURS HOURS MTL. TWG.
Reposition Generator End
Frame - - - 96 V2930 .5 *.1 -
* .1 hour for administration
To assure accurate records of all transactions on this campaign, it is recommended that campaign repairs for each vehicle be listed on a separate repair order. Other repairs performed to the vehicle may be listed on the same repair order, and warranty cases other than campaigns may be listed on the same warranty document.
Zone authorization is not required.