28 40 020 Removing and Installing or Replacing Clutch Support (GS7D36SG)

28 40 020 Removing And Installing Or Replacing Clutch Support (GS7D36SG)







IMPORTANT:
After completion of work, check gearbox oil level.
Use only the approved transmission oil
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.







IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESP protection).







Necessary preliminary tasks:
- Remove twin-clutch gearbox
- Remove clutch







Remove oil pump (1).
Unfasten screws (2).
There is another screw of the clutch support located under the oil pump drive wheel.
Tightening torque: 28 10 10AZ.
Remove clutch support (3).

Installation note:
Replace screws and seal.







IMPORTANT:
Before installing clutch support:
Make sure without fail that seal (1) is installed in correct position and piston rings are correctly fitted on drive shaft.







Installation of the clutch support:
Secure clutch support screw connections in diagonal sequence.
It is mandatory to comply with the specified order of screw connections 1-6.
1. Tighten all screws to 2 Nm
2. Loosen all screws again by (approx. 180°).
3. Then tighten fully.

Tightening torque: 28 10 10AZ.

(��:

rف:

��: