11 14 110 Removing and Installing Lower Timing Case Cover

11 14 110 Removing And Installing Lower Timing Case Cover (N63)

Special tools required:







Necessary preliminary work:
- Remove engine
- Remove both cylinder heads
- Remove lower oil sump section
- Remove upper oil sump section
- Remove alternator belt tensioner
- Remove vibration damper
- Remove coolant pump
- Remove alternator
- Remove A/C compressor
- Remove hub for vibration damper







Release screws along lines (1).
Remove timing case cover (2) towards front.
Clean sealing surfaces with special tool 11 4 470.







NOTE: Check jump guard for damage.

Release screw (1).
Tightening torque 11 14 1AZ. 00 00 Excerpt From Company Standard BMW GS 90003-2
Remove jump guard (2).







Clean sealing surfaces with special tool 11 4 470.

Installation note:
Preposition all bolts in timing case cover.
Replace beaded metal gaskets (1, 2 and 3).







Fit timing case cover (2).
Initially tighten all bolts to approx. 5 Nm.
Fully tighten all bolts in alternate sequence.
Tightening torque 11 14 2AZ. 00 00 Excerpt From Company Standard BMW GS 90003-2

Installation note:
Wait for PU material to emerge at sealing joints.
Carefully wipe off protruding PU material.







Replace radial shaft seal in gear case cover at bottom.
Assemble engine.