PROM - Programmable Read Only Memory: Technical Service Bulletins

• Recalls
  • Generals
    • Campaign - DME Reprogramming for Oil Service Interval
  • Safety
    • Recall 12V-502 - Program Control Units (Central Gateway Module
• Customer Interest
  • Computers/Controls - TEL Control Module Malfunction Msg
  • BMW Assist(R) - System Inactive Message is Displayed
  • Audio System - Popping/Crackling After Programming
  • Body - Door(s) Won't Latch Properly
  • A/T - Harsh 3-2/2-1 Downshifts/Clunk Noise
  • Engine Controls - A/T Goes Into Failsafe Mode/DTC's Set
  • Bluetooth(R) - Call Displays as Active After Ended
  • Lighting - Automatic Headlamps Don't Switch OFF
  • Computers/Controls - Various System Errors
  • Cell Phone - Won't Power Up When Cycling Ignition
  • Cell Phone - Can't Initiate a Voice Recognition Call
  • Engine Controls - Loss of Power Decelerating/Turning
  • Auxiliary Equipment - Erratic Electrical Malfunctions
  • Instruments - Engine Oil Service Reminder ON Too Early
  • Engine Controls - Harsh A/T Downshifts/'Clonk' Noise
  • Engine Controls - Loss of Power On Deceleration
  • Engine Controls - Intermittent Crank-No Start Condition
• All Technical Service Bulletins
  • Recall 12V-502 - Program Control Units (Central Gateway Module
  • Computers, Controls - Programming VS Veh. Data Status
  • Computers/Controls - TEL Control Module Malfunction Msg
  • BMW Assist(R) - System Inactive Message is Displayed
  • Audio System - Popping/Crackling After Programming
  • Progman(R) - Programming/Coding/Individualization
    • Overview
    • General_Rules_For_Programming
    • Procedure_A_Module_Replacement
    • Procedure_B_Software_Update
    • Procedure_C_Troubleshooting
      • Index
      • Introduction
      • Section I: Preparing A Progman Session
      • Section II: Progman Session Initialization
      • Section III: Before Programming/Coding
      • Section IV: After Programming Coding
      • Illustrations and Table
    • Procedure_E_Coding
  • Body - Door(s) Won't Latch Properly
  • A/T - Harsh 3-2/2-1 Downshifts/Clunk Noise
  • Progman(R) - Errors Corrected
  • Engine Controls - A/T Goes Into Failsafe Mode/DTC's Set
  • Bluetooth(R) - Call Displays as Active After Ended
  • Computers/Controls - 'Retrofit' Update Programming
  • Lighting - Automatic Headlamps Don't Switch OFF
  • Computers/Controls - Various System Errors
  • Cell Phone - Won't Power Up When Cycling Ignition
  • Computers/Controls - Progman(R) V22.0/V22.0.1 Errors
  • Engine Controls - Progman(R) V21.01 and V21.02.01 Errors
  • Cell Phone - Can't Initiate a Voice Recognition Call
  • Campaign - DME Reprogramming for Oil Service Interval
  • Engine Controls - Loss of Power Decelerating/Turning
  • Auxiliary Equipment - Erratic Electrical Malfunctions
  • Instruments - Engine Oil Service Reminder ON Too Early
  • Engine Controls - Harsh A/T Downshifts/'Clonk' Noise
  • Engine Controls - Loss of Power On Deceleration
  • Engine Controls - Intermittent Crank-No Start Condition