Installing Replacement Transmission

Remove transmission, refer to Removing and Installing Transmission.

Fit following parts from old transmission on the new transmission:
Release bearing and release lever, refer to Clutch M/T, Throw-Out Arm and Throw-out Bearing
Dowel pin for slave cylinder
Reverse light switch





Transfer shift-rod joint.
Slide back retaining ring (1) and drive out cylindrical pin (2).





Installation:
Check damping disc (6) (in joint) for damage and replace if necessary.





Remove breather (1) and protective sleeve (2) from selector shaft
Lift out sealing cap (3) and install breather (1).