A/T - Hard Shift/Downshift Clunk
GROUP 24Automatic Transmission
24 03 00
Woodcliff Lake, NJ
Service Engineering
November 2001
This Service Information bulletins supersedes S.I. 24 03 00 dated March 2000.
SUBJECT
Updated TCM/AGS Software for MY '99 & '00 540iA/iAT, 740iA/740iAL
MODEL
E38, E39 with M62TU produced from 9/98 up to 1/00
SITUATION
-- Customer may complain of an occasional "hard" 3-2 downshift or "clunk" when slowing.
-- Customer may complain of an occasional harsh downshift at freeway speed.
CAUSE
TCM/AGS calibration
CORRECTION
On a customer complaint basis, reprogram the TCM/AGS with CD 27.0 or higher.
PROCEDURE
1. Check the TCM/AGS identification screen to obtain the "software number".
2. No programming is necessary if the software number is "1719".
An automatic determination, to identify the control module version, can be used to reprogram the TCM/AGS in a '99 or '00 MY 540iA/iAT or 740iA/iAL. A battery charger should be used when reprogramming.
3. Select:
Programming
-- AGS/EGS programming
-- Exchange control unit
-- Determine basic control unit
-- "Is faulty control unit installed in car?"... select "Yes"
-- Enter VIN
-- Program basic control unit (takes approximately 15 minutes)
-- Clear adaptation values
-- Verify correct program version by checking TCM/AGS ID screen again:
New Program Software Number (after reprogramming)
Model Type AGS Version SW number
Sport 8.60.2 1719
Standard 8.60.2 1719
Covered under the terms of the BMW New Vehicle Limited Warranty.
INFORMATION
Defect Code 24 00 91 61 00
Labor Operation: 00 52 261 Reprogram TCM/AGS module
Labor Allowance: 8 FRU E39
7 FRU E38