11 14 085 Removing and Installing Timing Case Cover, Top Right (M62 Up to 9/98)

11 14 085 Removing and installing timing case cover, top right (M62 up to 9/98)

Remove right cylinder head cover. These tasks are described in the work step. Removing and installing/sealing both cylinder head covers. Service and Repair
Remove piston for chain tensioner, refer to Timing Chain Tensioner. Service and Repair





Remove camshaft sensor.





Unfasten top screw from dipstick tube.





Unfasten timing case cover.





Remove rubber sealing strip.

Installation:
Clean groove for rubber profile seal and sealing surfaces of remains of seal.





Installation:
Replace sealing ring in cylinder head for oil supply of chain tensioner





Installation:
Keep sealing faces clean and free of oil.
Apply coat of Drei Bond 1209 to joint between cylinder head and lower timing case cover (or equivalent).





Seat new rubber seal in groove.





Installation:
Ensure that seals are correctly seated.
Press bow cover inwards and fit timing case cover.
Install screws (1) and fit flush with cylinder head.





Installation:
Remove outer and inner gasket from cylinder head cover.
Insert special tool 11 1 411 from special tool kit 11 1 410 in groove of cover and fit cylinder head cover.





Installation:
Install cover nuts (1) and tighten down uniformly in 1/2 turn steps.
Tightening Torque, refer to Engine, Specifications.

Note: The timing case cover is pressed down onto level of cylinder head by cylinder head cover.





Installation:
Tighten screws (1) on timing case cover in two passes.

Remove cylinder head cover and remove special tool 11 1 411.
Assemble engine.