11 14 080 Removing and Installing Timing Case Cover, Top Left (M62 Up to 9/98)

Removing and installing timing case cover, top left (M62 up to 9/98)

Remove left cylinder head cover. These tasks are described in the work step. Removing and installing/sealing both cylinder head covers. Service and Repair
Remove fan clutch with impeller, refer to Cooling System. Service and Repair





Unfasten timing case cover.





Remove rubber sealing strip.

Installation:
Clean groove for rubber profile seal and sealing surfaces of remains of seal.





Installation:
Keep sealing faces clean and free of oil.
Apply coat of Drei Bond 1209 to joint between cylinder head and lower timing case cover (or equivalent).





Seat new rubber seal in groove.





Installation:
Ensure that seal is correctly seated, then fit timing case cover with inserted screw (1).

Note: It is not possible to insert screw (1) after fitting the timing case cover.





Installation:
Install screws (1) and fit flush with cylinder head.





Installation:
Remove outer and inner gasket from cylinder head cover.
Insert special tool 11 1 412 from special tool kit 11 1 410 in groove of cover and fit cylinder head cover.





Installation:
Install cover nuts (1) and tighten down uniformly in 1/2 turn steps.
Tightening Torque 11 12 11AZ

Note: The timing case cover is pressed down onto level of cylinder head b) cylinder head cover.





Installation:
Tighten screws (1) on timing case cover in two passes.

Remove cylinder head cover and remove special tool 11 1 412.
Assemble engine.