Without Load Dependent Dampening (LAD)

Models without LAD

1. Disconnect plug on low pressure switch and bridge wire harness side.
2. Turn ignition On.
3. Disconnect regulating rod on front joint and operate lever on regulating switch toward rear in ``discharging'' direction. This will discharge system of lines in approximately 20 seconds.
4. Remove spare tire and cover.
5. Loosen clamp and remove oil pipe on hydraulic control unit.
6. Loosen screws and remove tank.
7. Disconnect electrical plug and ground wire from control unit.
8. Loosen bolts and remove hydraulic control unit.
9. Reverse procedure to install.
10. Turn ignition On and operate lever in forward ``charging'' direction until switch stops pumping. Add fluid as necessary.