Disconnecting From Wiring Harness Connector

Disconnecting From Wiring Harness Connector

Do not excessively bend or kink fiber optic cables. (minimum bending radius 25 mm).

Removal






- Unplug connector for fiber optic cable from appropriate control unit.

- Release locking latch in fiber-optic cable connector - arrow -.

- Pull base module - 2 - for fiber-optic cable from connector housing - 1 -.













• Mark allocation of fiber-optic cable - 5 - to the appropriate connector socket in base module - 1 - with color marking.

• Note the arrows - 3 - for allocation on the base module "IN" and "OUT".

- Release secondary latch - 6 - (blue pin) using a small screwdriver - arrow -.

- Release catch - 2 - and remove fiber-optic cable - 5 - with brass connector pin - 4 - from base module - 1 -.

Installation

Install in reverse order of removal. Note the following:

- Install fiber optic cable in line with markings.

• Seal open harness connector - 2 - for fiber-optic cable using Protective Cap For Cable Connector (VAS 6223/9) - item 1 -.






• Protective cap prevents contamination of or mechanical damage to end face of fiber optic cable which would impair signal transmission.

- Install fiber optic cable in line with markings.