Rollover Protection Assembly Overview

Rollover Protection Assembly Overview

• Loosen only those screws shown in the illustration.

• Never remove the support panels from the rollover protection.






1 Bolt

• 23 Nm

• Quantity: 6

• If it was removed because of an accident, replace the bolt

• Tightening sequence => [ Rollover Protection Tightening Sequence ]

2 Bracket

• For the connector

• Removing and installing, refer to => [ Connector Bracket ] Connector Bracket

3 Bolt

• 23 Nm

• Quantity: 4

• If it was removed because of an accident, replace the bolt

4 Bolt

• 23 Nm

• Quantity: 4

• If it was removed because of an accident, replace the bolt

5 Rivet Nuts

• Quantity: 6

• Removing and installing, refer to => [ Rear Headrest Pop Rivet Nut ] Rear Headrest Pop Rivet Nut

6 Trim

• Quantity: 2

• Clipped to the rollover protection

• Removing and installing, refer to => [ Anti-Roll Bar Trim ] Anti-roll Bar Trim

7 Rollover Protection

• Anti-roll bar shown in its extended position

• Removing and installing, refer to => [ Rollover Protection ] Rollover Protection

• measure in the body, refer to => [ Rollover Protection in Body, Measuring ] Rollover Protection In Body, Measuring

8 Guide

• Installed inside the anti-roll bar

• Removing and installing, refer to => [ Rollover Bar Guide ] Rollover Bar Guide

9 Bolt

• 23 Nm

• Quantity: 4

• If it was removed because of an accident, replace the bolt

10 Bolt

• 23 Nm

• Quantity: 4

• Pre-installed loose in the replacement part

• If it was removed because of an accident, replace the bolt

11 Adjusting Screw

• For the side trim

12 Bolt

• 23 Nm

• Quantity: 4

• If it was removed because of an accident, replace the bolt

Rollover Protection Tightening Sequence





- Tighten the rollover protection bolts in sequence - 1 through 6 -.