Front Suspension

Electronic Damping Control Module

Removing






• The electronic damping control module (J250) is located behind the right luggage compartment side trim panel.

- Switch off all electrical consumers.

- Remove the ignition key.

- Remove the cover from the right luggage compartment storage compartment.

- Remove the towing recognition control module (J345) - 1 - from the control module bracket - 2 -, where applicable.

- Remove the nuts - arrows -, pull the control module bracket - 2 - off the threaded pins and move it downward.

- Open the clamps - A - and - B - and remove the electronic damping control module - 1 - from the control module bracket - 2 -.






- Unlock the connector - 3 - and disconnect it from the electronic damping control module - 1 -.

- Remove the electronic damping control module - 1 -.

Installing

Installation is the reverse of removal, with special attention to the following:

- Adapt the electronic damping control module. Refer to => [ Control Position, Programming using VAS 5051B ] Testing and Inspection.