Front Brake Caliper Assembly Overview

Front Brake Caliper Assembly Overview

• Install complete repair kit when servicing.

• Apply thin coat of assembly paste (G 052 150 A2) to brake cylinders, pistons and seals.






1 - Bolt

• 30 Nm

2 - Protective cap

• Insert in brake caliper

• Replacing, refer to => [ Protective Cap and Guide Pins, Replacing ] Protective Cap and Guide Pins, Replacing

3 - Guide pins

• Slide through the boot

• Replacing, refer to => [ Protective Cap and Guide Pins, Replacing ] Protective Cap and Guide Pins, Replacing

4 - Protective cap

• Install on the bleeder valve.

5 - Bleeder valve

• Apply a thin coat of assembly paste (G 052 150 A2) to the threads before screwing in.

• 15 Nm

6 - Brake caliper housing

7 - Retaining spring

• Ensure installation position is correct.

8 - Protective cap

• Do not damage when installing piston

• Coat with Assembly Paste (G 052 150 A2)

9 - Pistons

• First apply thin coat of brake cylinder paste (G 052 150 A2) on piston

• Diameter 57 mm.

10 - Seal

• Coat with assembly paste (G 052 150 A2).

11 - Brake carrier

• Removing and Installing, refer to => [ Brake Caliper with Front Brake Carrier ] Brake Caliper With Front Brake Carrier

• The 4 retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.

12 - Bolt

• 196 Nm