Image Processing Control Module (J851)

Image Processing Control Module (J851)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)

Removing

• The image processing control module is located in the footwell in front of the front passenger seat.

• If the image processing control module is replaced, then the program must be started on the vehicle diagnostic tester in "Guided Functions".

- Remove the sill panel strip.

- Remove the floor mat.

- Remove the foot rest.

- Loosen the front passenger seat and push it to the rear with the wires still connected.

- Disengage the floor covering and push it to the side.

- Remove the nuts - arrows -.






- Remove the bolts - 1 through 4 - and remove the bracket - 5 - from the image processing control module.

- Unlock the connector - 1 and 2 - and disconnect it from the image processing control module - 3 -.






Installing






Install in reverse order of removal. Note the following:

Tightening specifications nuts - arrows - 2.5 Nm

Tightening specifications bolts - 1 through 4 - 8 Nm

If it necessary to replace the image processing control module, then start the program on the vehicle diagnostic tester in "Guided Functions".