Camera Control Module (J852) and Lens Trim

Camera Control Module (J852) and Lens Trim

Camera Control Module and Lens Trim Assembly Overview






1 Retaining Plate

• With windshield heating for the camera control module.

• Cannot be separated from the windshield.

2 Lens Trim

3 Electrical Connection

4 Cover Trim

5 Camera Control Module (J852)

6 Electrical Connection

7 Windshield

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)

• Special Hook (3370)

Removing

• If the camera control module is replaced, then the program must be started on the vehicle diagnostic tester in Guided Functions.

- Release the - 1 - camera control module trim piece for the retaining plate in direction of - arrow A - using (3370) - 2 - alternating from right to left and then remove it downward in direction of - arrow B -.






- Free up the electrical wires if necessary.

- Push the locking tabs - 2 and 4 - upward.






• Carefully press the locking tabs upward just enough until it is possible to guide the camera control module past.

- Remove the camera control module - 1 - to the rear, parallel to the retaining plate - 5 -, in direction of - arrow 3 - and out of the retainers - arrows - on the retaining plate - 5 -.

- Disconnect the connector - 2 and 3 - and remove the camera control module - 1 -.






Removing the Lens Trim






- Squeeze the clips - arrows - and remove the lens trim from the bracket.

Installing

Install in reverse order of removal. Note the following:

• The camera visual area on the inside of the window must not be covered with condensation or dirty. If it is, clean the visual window by hand using a cleaning solution.

• If the camera control module was remove and installed or replaced, then the camera and the camera control module must be calibrated. Refer to => [ Camera Control Module (J852), Lane Assist, Calibrating ] Testing and Inspection.