Rear Window Shaft Strip

Rear Window Shaft Strip

Special tools, testers and auxiliary items required

• 3 x removal hook (T40219)

Removing

- Move the window into the "open" position.

- Door trim removed.

- C-pillar trim removed.

- Before the window shaft strip - 1 - can be removed, first disconnect it from the door hooks - arrows -.






- Insert the first (T40219) between the door window and the window shaft strip on the trim for the C-pillar.






- Slide the first (T40219) sideways and towards the front to dimension a.

- Pull the first (T40219) upward and slide it into place into the window shaft strip.

• The mark on the (T40219) must line up with the upper edge of the window shaft strip.

- Insert the second (T40219) between the door window and the window shaft strip on the trim for the C-pillar.

- Move the second (T40219) to dimension b and fit it in from underneath.

- Insert the 3rd (T40219) on the C-pillar trim and move it to dimension c.

* The specified dimensions on the window shaft strip are measured starting at the B-pillar.

• Dimension a = 240 to 275 mm.

• Dimension b = 425 to 460 mm.

• Dimension c = 605... 640 mm.

- Gently push the (T40219) outward and release the window shaft strip.






- Release the window shaft strip completely in stages and then remove it upward from the door flange.






Installing

The hooks on the outer door panel and door window must not be pried open and must touch the door window completely, if necessary, they must be bent back into their original shape.

• Beginning at the B-pillar, press the window shaft strip completely into the retaining hooks in the door.