Leak Detection Pump

Leak Detection Pump

Removing

- Remove right rear wheel housing liner.

- Disconnect vent line - 1 -.





- Separate the electrical connector - 2 -.

- Disconnect vent line - 3 - by pressing release button.

- Remove nuts - arrows -.

- Disengage diagnostic pump with bracket.

Installing

• Tightening specifications, refer to => [ EVAP Canister System/Leak Detection System Overview ] EVAP Canister System/Leak Detection System Overview.

Installation is in reverse order of removal, note the following:

• Vent line - 3 - must engage audibly.

- Install right rear wheel housing liner.