Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Accelerator Pedal Module With Throttle Position Sensors






Accelerator Pedal Module with Throttle Position Sensors

Special tools, testers and auxiliary items required

Release Tool (T10238)

Removing

- Remove cover for steering column - arrows -.






Version I

- Disconnect electrical harness connector - 2 -, by pressing release button to the stop - arrow -.






- Where necessary, pull the wiring router - 1 - off from the accelerator pedal module.

Version II

- Disconnect the electrical connector - 2 - on the accelerator pedal module by pulling the release - 1 - up as far as the stop - arrow -.






All Vehicles:

- Pry off the cover using a screwdriver - 4 - => [ Cap ] Accelerator Pedal Mechanism Assembly Overview.

- Remove the bolt - 5 - => [ Bolt ] Accelerator Pedal Mechanism Assembly Overview.

- Push the (T10238) into the intended openings - arrow - up to the stop, as shown, and remove the accelerator pedal module.






Installing

Tightening specifications, refer to => [ Accelerator Pedal Mechanism Assembly Overview ] Accelerator Pedal Mechanism Assembly Overview.

Installation is in reverse order of removal, note the following:

- Connect the wiring router - 1 - and the electrical connector - 2 - to the accelerator pedal module - 5 -.






The connector must engage audibly.

- Push the accelerator pedal module onto the securing studs - 6 -.

- Insert centering pin - 7 - into hole on the underbody.

- Secure the accelerator pedal module with the bolt - 3 - and install the cap - 4 -.

A02250352921-050310