Windshield Wiper Motor With Windshield Wiper Motor Control Module

Windshield Wiper Motor with Windshield Wiper Motor Control Module

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Special tools, testers and auxiliary items required

• Pry lever (80 - 200)

Removing





- Remove wiper arms. Refer to => [ Windshield Wiper Arms ] Removal and Replacement.

Vehicles through 05.08

- Remove the seal - arrow -.

- Unclip the plenum chamber cover - 1 through 3 - and remove it.

Vehicles from 06.08





- Remove the bolts - 3 -.

- Remove the clips - 2 - from the mounts and remove the plenum chamber cover- 1 -.

All vehicles





- Remove the securing clips - 2 - - arrow A -.

The cowl panel trim could be damaged.

• Coat the space between the windshield and the cowl panel trim with some soapy water.

- Carefully remove the cowl panel trim - 1 - starting at the edge of the glass vertically from the windshield - arrows B -

- Disconnect the electrical connector - 2 -.





- Remove the drain channel - 3 - on the linkage - arrow A -.

- Remove the bolts - 4, 5 and 6 -.

- Rotate the wiper arm frame - 1 - with the linkage and wiper motor upward - arrow B - and pull it forward out of the plenum chamber.

Installing

• Tightening specification => [ Windshield wiper motor, tightening
specifications and sequence ] Windshield Washer System Assembly Overview.

Install in reverse order of removal, observing the following:

- Insert wiper motor with wiper frame into vehicle.

- Tighten bolts => [ Windshield wiper motor, tightening
specifications and sequence ] Windshield Washer System Assembly Overview.

- Position the water drain channel on the wiper motor.

- Adjust wiper arms. Refer to => [ Windshield Wiper Arms, Adjusting ] Adjustments.