Rollover Protection Assembly Overview

Rollover Protection Assembly Overview


• Loosen only those screws shown in the illustration.

• Never remove the support panels from the rollover protection.





1 Bolt

• Quantity: 6

• If it was removed because of an accident, replace the bolt

• 23 Nm

• Tightening sequence, refer to => [ Rollover protection tightening sequence ]

2 Bracket

• For the connector

• Removing and Installing, refer to => [ Connector Bracket ] Connector Bracket

3 Bolt

• Quantity: 4

• If it was removed because of an accident, replace the bolt

• 23 Nm

• Tightening sequence, refer to => [ Rollover protection tightening sequence ]

4 Bolt

• Quantity: 4

• If it was removed because of an accident, replace the bolt

• 23 Nm

• Tightening sequence, refer to => [ Rollover protection tightening sequence ]

5 Rivet nuts

• Quantity: 6

• Removing and Installing, refer to => [ Rear Headrest Pop Rivet Nut ] Rear Headrest Pop Rivet Nut

6 Trim

• Quantity: 2

• clipped to the rollover protection

• Removing and Installing, refer to => [ Anti-roll Bar Trim ] Anti-roll Bar Trim

7 Rollover Protection

• Anti-roll bar shown in its extended position

• Removing and Installing, refer to => [ Rollover Protection ] Rollover Protection

• measure in the body, refer to => [ Rollover Protection in Body, Measuring ] Rollover Protection in Body, Measuring

8 Guide

• Installed inside the anti-roll bar

• Removing and Installing => [ Anti-roll Bar Guide ] Anti-roll Bar Guide

9 Bolt

• Quantity: 4

• If it was removed because of an accident, replace the bolt

• 23 Nm

• Tightening sequence, refer to => [ Rollover protection tightening sequence ]

10 Bolt

• Quantity: 4

• Pre-installed loose in the replacement part

• If it was removed because of an accident, replace the bolt

• 23 Nm

• Tightening sequence, refer to => [ Rollover protection tightening sequence ]

11 Adjusting screw

• For the side trim

12 Bolt

• Quantity: 4

• If it was removed because of an accident, replace the bolt

• 23 Nm

• Tightening sequence, refer to => [ Rollover protection tightening sequence ]

Rollover protection tightening sequence





- Tighten the rollover protection bolts in sequence - 1 through 6 -.

Tightening specifications, refer to => [ Rollover Protection Assembly Overview ].