Rear Brake Disc

Rear Brake Disc

Removing

- Raise vehicle.

- Remove wheels.

- Remove brake hose and electrical wire from the bracket on the stub axle carrier

- Remove brake caliper with the brake pads and brake carrier. Refer to => [ Rear Brake Caliper with Brake Carrier ] Rear Brake Caliper With Brake Carrier.

Do not let the brake caliper with the brake carrier hang from the brake hose. Secure it to the body with suitable cable ties or wire. Do not support the weight with the brake hose.


Do not press the brake pedal when the caliper is removed.

- Remove securing bolt - arrow - on the brake disc while holding the disc firmly.





- Remove brake disc from the wheel hub.

• When removing the brake disc from the wheel hub, do not tilt the disc.

Installing

• Replace bolts

Clean brake disc, wheel hub and contact surfaces before installing.

- Place brake disc on the hub.

• When positioning the brake disc, do not tilt it on the wheel hub.

- Install securing bolt - arrow - and tighten.





- Install brake caliper with brake carrier. Refer to => [ Rear Brake Caliper with Brake Carrier ] Rear Brake Caliper With Brake Carrier.






• Use an extension to tighten the lower bolt - 16 -. An extension is not needed to tight the upper bolt - 17 -. Slightly move the wheel housing liner away.

- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

• Make sure the brake hose and wiring is correctly attached and secured inside the bracket on the stub axle carrier. This will prevent the hose and wiring from coming out to the bracket.

- Install wheels.

- Lower vehicle.